16751HPS Thin and 1 cm shorter left drive shaft for VW Golf 5/6 Passat 3C

MAPCO 16751HPS Thin and 1 cm shorter drive shaft left for VW Golf 5 / 6 Passat 3C
The car drive/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. By dividing the cardan shaft, low-vibration operation is achieved and noise is avoided. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern shows traces of grease, particularly on the front vehicle doors, which are thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also be cracking noises when the load changes. Porous sleeves should be replaced soon.

Article information:

Installation side: front axle left

Length: 476.0 mm

Bore diameter: 10.2 mm

Thread size: M16X1.5

External toothing wheel side: 36

Seal ring diameter: 59.5 mm

Number of bores: 6

Bore circle diameter: 94 mm

Chassis: for vehicles with lowered chassis

for shaft diameter: 27.0 mm

Joint diameter wheel side: 98 mm

Joint diameter gearbox side: 108.0 mm

Suitable for the following vehicles:

VW TOURAN (1T1, 1T2) 1.9 TDI

VW PASSAT Variant (3C5) 2.0 TDI 16V

VW PASSAT Variant (3C5) 2.0 TDI

VW PASSAT ALLTRACK (365) 2.0 TDI

W TOURAN (1T1, 1T2) 2.0 TDI 16V VW TOURAN (1T3) 2.0 TDI VW TOURAN (1T1, 1T2) 2.0 TDI AUDI A3 (8P1) 2.0 TDI 16V AUDI A3 Sportback (8PA) 2.0 TDI 16V AUDI A3 (8P1) 2.0 TDI AUDI A3 Sportback (8PA) 2.0 TDI SKODA OCTAVIA II Combi (1Z5) 2.0 TDI 16V VW GOLF V (1K1) 2.0 TDI 16V VW GOLF V (1K1) 2.0 TDI VW GOLF VI (5K1) 2.0 GTi SKODA YETI (5L) 2.0 TDI 4x4 SKODA OCTAVIA II Combi (1Z5) 2.0 TDI VW TOURAN (1T1, 1T2) 2.0 TDI
VW GOLF V (1K1) 2.0 GTI
VW GOLF PLUS (5M1, 521) 2.0 TDI 16V

If the car is not listed, please send a copy of the vehicle registration document by email to shop@schalk-tuning.de before ordering or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.